WUPP ZH-983B6 Motorcycle Modified Intelligent Electric Heating Hand Cover Heated Grip with Three Gear Temperature Control

1. Material: nitrile

2. Handle length: left handle: 143x36mm; right handle: 127x36mm

3. Suitable pipe diameter: 22mm

4. Input voltage: DC12V

5. Product power: red light 35W, blue light 25W, green light 17W

6. Handle temperature: low temperature 40 degrees Celsius, medium temperature 50 degrees Celsius, high temperature 60 degrees Celsius

7. Switch type: multi-stage adjustable temperature control switch

8. Applicable models: 12V motorcycle with a handlebar diameter of 22mm

9. Product accessories: 3M glue x1, rear-view mirror fixing bracket x1

10. One-piece molding to prevent rain and dust from entering the internal corrosion parts, longer service life and safer

11. Built-in intelligent temperature control chip, three-speed adjustable temperature, intelligent temperature control is safer

12. Double throttle cable buckle, wider installation range

13. The design can be sealed and can be opened, which will not affect the installation of the handle outside the handle, and only the lights and other decorative accessories can be used, which is more beautiful and convenient

14. The product has added a standby mode. After switching to the standby state, the electric heating handle will automatically maintain a constant temperature of about 50 degrees, and it will automatically shut down after two hours. There is no need to worry about running out of the battery of the motorcycle because of forgetting to turn off the switch.

Installation notes:

1. Remove the original handlebar

2. Use the left hand to moisten the inner hole with soapy water, and the twist should not be too large during installation

3. When installing the balance iron on the left hand handle, adjust the position of the balance iron to be slightly separated from the handle, and do not squeeze the handle when tightening the screw

4. If you use the left handle to slide on a steel pipe, remove the balance iron and fix it with a few drops of 502 glue from the end of the handle

5. The power cord, the red wire is connected to the positive pole, and the black wire is connected to the negative pole, please confirm before connecting it, and do not reverse the connection

6. When installing the left-hand handle, the power cord should be left enough for rotation

7. Put the switch L-shaped bracket on the rearview mirror, fix it to the rearview mirror base, and tighten it.

Precautions:

1. When installing the left handle, do not twist the handle too much. Excessive twisting will cause the heating wire to shift.

2. For models with balance iron, please adjust the installation position of the balance iron. Do not squeeze the handle when tightening the screws. The balance iron is slightly separated from the handle. If the installation position of the balance iron cannot be adjusted, please add a spacer between the balance iron and the handle. Excessive squeezing of the handle may cause difficulty in turning the handle switch and abnormal damage such as the heating wire squeezing out of the handle surface.