$0.00
CheckoutStop lights for vehicle
Each driver must ensure that their vehicle is in good condition and
that they do not create an emergency. Brake light bulbs are a must on all vehicles because they warn
other drivers of the car that your car is braking. The driver does not switch brake lights car on
purposefully compared to other car warning lights. It happens automatically
when you press the brake pedal.
General information about brake lights
The car brake
light bulbs are located symmetrically on both sides of the body. Their
light should be brighter than the side lights. Such a signal should immediately
turn on even with a slight pressure on the brake pedal. When lightly pressed, a
button is installed under the brake, closing the electrical circuit.
Brake lights for cars have different design solutions, and they can also be placed in the
spoiler or behind the car's rear window. Often, these signal lights are bulbs
built into the car body. In addition, when the security system is activated,
the car's brake lights automatically turn on and start flashing, saying,
"Brake immediately; the car is driving in extreme mode."
There are also additional rear bulb brake light installed at the end of the car
in the upper part of the body. Its purpose is to anticipate the braking of the
second vehicle in front of you. Such a signal is visible through the windshield
and rear window of the car in front of your vehicle.
Sometimes, the new
brake lights circuit in the car is used by gearboxes, and if, in the
event of a failure or incorrect sensor settings, these warning lamps can fail,
then the stop and tail
bulb will need to be replaced.
Briefly about the device signal lights
The auto brake
light bulbs have a long-term unchanged design. It indicates the
simplicity and reliability of this device. A traditional brake light has three
main components: lights, wiring, and a switch. The design of the button is as
follows: a body, two terminals, a stem, and a spring.
The bulb for brake
light is attached to the brake pedal. When the brake is pressed, the
stroke of the rod occurs, which leads to the closure of the contacts. If the
brake pedal is released, the lights will go out, as the spring will push the
stem back. This sensitive system ensures that the car's automotive brake lights light up a little
before the start of braking, warning other drivers.
The reliability and quality of stop lamps are a must
Reliable and high-quality brake light replacement bulbs are essential for road safety. And
if you need to replace brake light bulbs, then the All Automotive Accessories
website can provide such products, where you will find various such bulbs.
Let's consider some of them.
Pair of brake lights DC 12V IP67, 4-in-1
Brake lights bulbs
replacement are made of black ABS resin material. The
color temperature reaches 6000-6500K, and the service life is up to 50,000
hours. Waterproof IP67.
Car LED brake lights 1.2W, 1157 BAY 15D
If you need to replace stoplight bulb, this is the right choice: low power consumption,
high brightness, and easy installation that any driver can handle.
LED brake light Т20 3157 DC
This brake light
for car has a DC 12V voltage, 0.24W power, 0.02A current, and 60 lumens.
It has a small power consumption and is easy to install. There is a large
selection of case colors in stock.
Car brake light with 10 bulbs CREE XB-D
The brake lamp
bulb is designed for 12V DC, base BAY 15D. The significant term of
operation is made of shock-resistant material that has a bright red color. Your
car's brake light alerts other drivers when you're braking. Therefore, it is
essential that they are of high quality and do not malfunction.