2 in 1 GPS Navigation Car Antenna Signal Amplifier

1. Contains: 1 GPS antenna (wire length 5 meters, SMA head) 1 GPS amplifier (wire 30 cm, SMA female head)

2. Power supply mode: USB5V

3. Weight: 144 grams

4. Applicable situation: GPS signal amplifier is an auxiliary receiving tool, which has a good improvement effect on the deterioration of GPS signal caused by filming etc.

5. How to use:

-Put the GPS antenna outside the car, it is generally recommended to put it near the license plate or rear glass, the signal line enters the car through the gap in the tail box

-Put the GPS amplifier near the antenna of the integrated car navigation system (or mobile phone navigation)

-Connect the antenna connector SMA male and SMA female.

-Plug the USB interface to the cigarette lighter to take 5V power

-The power light on the amplifier is on

6. Matters needing attention:

-When installing, try to place the antenna and amplifier as far away as possible

-Open the navigation map

-Adjust the position of the antenna so that more satellites can be found on the navigation