How not to spoil the body when polishing: 8 Mistakes

It will be easier for people to take their car to the salon to have professionals polish their body. However, such services are quite expensive and may not be available for a number of other reasons. That is why many car enthusiasts do it themselves, using a buffing polishing machine. But inexperienced vehicle owners often make mistakes and the body suffers greatly.

Introduction

Most car owners prefer to polish the car body themselves with an auto buffing machine. This is often due to the following reasons:

• the high cost of maintenance;

• the remoteness of the service;

• work is not always performed in good faith.

In addition, when you polish your car yourself with polishing accessories, you get aesthetic pleasure from the result achieved. It is necessary to polish the body not only because of the loss of the original shine but also if small scratches are detected. To achieve the desired result, it is important to avoid common mistakes.

8 mistakes when polishing a car's body

When polishing a car with a buffing and polishing machine, vehicle owners often make mistakes that lead to poor results. And then we will list them.

Polishing takes place outside

Since it is inconvenient to carry out operations in the garage due to cramped conditions, drivers do it on the street. However, during operation, small particles settle on the surface of the machine. This leads to scratching the surface of the car body. Therefore, the result cannot be achieved.

The body surface is not prepared properly

Contactless washing does not always perfectly clean the surface of the car. There will still be fine sand and dust particles on the body. There may also be unnoticeable areas of fat film. Therefore, before you start polishing with a car polish grinder, it is necessary to thoroughly wash and dry the body.

Protect vulnerabilities

Not all car owners protect vulnerable areas of the body before polishing. These include various chrome parts. This leads to undesirable consequences that will be almost impossible to correct. Therefore, before polishing, all vulnerable areas should be covered.

Information about the work was taken from the Internet

The data found cannot always serve as a guide to action. There are so many authors and so many tips. It is difficult to find a truly high-quality methodology from all the content. It is better to look through a lot of information, read reviews of those who applied these tips, and only then settle on a specific option.

Selection of polishing products

Before purchasing a professional polishing machine, you must carefully study the instructions. Without doing this, you can damage the car's paintwork, and restoration will take not only time but also money. Therefore, when purchasing polishing products, it is important to familiarize yourself with the technology for performing the work and strictly follow the manufacturer’s instructions.

Applying the excess paste to the polishing wheel

Many people think the more paste on the polishing wheel, the better. This is a misconception since the paste will be located not only between the pores but also on the surface of the circle. Therefore, polishing will not be performed – the paste will simply be spread over the body without a polishing effect. Quality is achieved by blowing the circle while filling the pores with paste.

Not using a thickness gauge

It is almost impossible to determine the thickness of the paintwork without a thickness gauge. People need to know where the varnish is thinner. This will prevent damage to the coating during polishing. Therefore, before polishing, you need to measure the thickness of the varnish on all parts of the body and only then start working.

Polishing in low light

In poor lighting conditions, it will not be possible to achieve high-quality results. You may miss some problem areas or damage the body paint. If the above errors are excluded, then the work on car polishng will be completed efficiently and without defects in the paintwork.