Portable Multifunction Car Bike Wireless Inflatable Pump (Blue)

1. Temperature: 20-7 degrees Celsius

2. Charging: Micro USB

3. Air efficiency: 2 minutes

4. Charging time: 2 hours

5. Material: metal + plastic

6. Size: 250x55x47mm

7. Net weight: about 750G

Instructions:

1. Insert the pin of one end of the charger into the car USB in advance, and plug the other end of the USB plug into the USB socket on the top of the pump to charge the pump. The normal charging time is 4 hours after the first charge and until each charge is fully charged.

2. Connect one end of the tire inflation connector to the air cylinder, and press the other end into the tire valve core, and then press down the reverse buckle. Please note that the connection sequence is very important; at the same time, pay attention to distinguish between American and French pipe joints. The joint of the trachea itself is American, and the independent French joint should be screwed to the American joint for use.

3. Power on button, the LCD screen starts to display, press it again to start switching between the four units of PSI, BAR, KAP, KG/CM, select the unit you want, set the button to set the air pressure value you need, and finally press Press the power switch to start inflation. When inflating, the LED at the bottom of the cylinder lights up.

4. The setting key is the pressure value setting key, click for slow adjustment, long press for fast adjustment, adjust to the appropriate pressure value of the inflated object; the pressure value flashes for 4 seconds, automatically set, or press the switch to set .

5. Press the power switch, when the inflation pressure reaches the pressure value you set, the smart inflator will automatically stop the inflation work immediately, but the LED light is still on, and then press the power switch to turn off the light.

6. When the inflation is over, quickly unscrew the tire inflation connector from the valve core or counterclockwise. Before unscrewing, be careful to check whether the tire inflation connector is hot; there will be a small amount of air leakage at the moment of unscrewing the connector, which is normal.

7. If it is judged that the tire pressure is too high, you can use the tire inflation connector to rotate on the appropriate position on the valve core to deflate and reduce pressure.